Datasheet 搜索 > DA转换器 > ADI（亚德诺） > AD5693RBRMZ 数据手册 > AD5693RBRMZ 数据手册 11/16 页
器件3D模型￥ 42.063
AD5693RBRMZ 数据手册 - ADI（亚德诺）
制造商:
ADI（亚德诺）
分类:
DA转换器
封装:
MSOP-10
描述:
ANALOG DEVICES AD5693RBRMZ 数模转换器, 16 bit, 串行, 2.7V 至 5.5V, MSOP, 10 引脚
Pictures:
3D模型
符号图
焊盘图
引脚图
产品图
页面导航:
导航目录
AD5693RBRMZ数据手册
Page:
of 16 Go
若手册格式错乱，请下载阅览PDF原文件
SDP-S User Guide UG-291
Rev. A | Page 11 of 16
1.75mm
5.90mm
3.30mm
5.15mm
60 61
1 120
50.50mm
ORIGIN (0,0)
NO RIGHT-ANGLED CONNECTORS ALLOWEDALONG THIS EDGE
x = 5.9mm, y = –3.3mm
x = 5.95mm, y = –53.8mm
EVAL-xxxxx-DB
Rev. D
D3.10mm
12.65mm
PLACEMENT KEEPOUT FOR COMPONENTS
OVER 3mm IN HEIGHT
(EXTENDS DOWN ENTIRE HEIGHT OF LEFT HAND SIDE OF PCB)
D3.10mm
x = 5.95mm, y = –28.55mm (CENTER OF CONNECTOR)
09916-006
Figure 6. Connector Placement on Compatible Daughter Boards
Keep Out Area
To allow the greatest flexibility for future controller boards, a
keep out area is established for components higher that 3 mm.
The keep out area is 12.65 mm wide and extends down the
entire left side of the daughter board.
Restriction on Right Angle Connectors
Due to the layout of other boards in the SDP family, and their
daughter boards, right angle connectors are not allowed on the
top and left edges of the daughter boards and (if required)
should be placed on the right or bottom edges. A right angle
connector describes any connector that requires the connection
to protrude over the edge of the board (for example, right angle
SMB or screw terminal).
MECHANICAL SPECIFICATIONS
The mechanical specifications of the SDP-S board are 2.36 inch
× 0.87 inch (60 mm × 22 mm). The tallest component on the
top is approximately 0.17 inch (4.3 mm), and the tallest compo-
nents on the bottoms are the 120-pin connectors at approximately
0.152 inch (3.86 mm). Refer to Figure 7.
器件 Datasheet 文档搜索
AiEMA 数据库涵盖高达 72,405,303 个元件的数据手册，每天更新 5,000 多个 PDF 文件
