Datasheet 搜索 > National Semiconductor（美国国家半导体） > LM3886TF/NOPB 数据手册 > LM3886TF/NOPB 数据手册 4/24 页
器件3D模型￥ 87.167
LM3886TF/NOPB 数据手册 - National Semiconductor（美国国家半导体）
制造商:
National Semiconductor（美国国家半导体）
封装:
TO-220
Pictures:
3D模型
符号图
焊盘图
引脚图
产品图
页面导航:
导航目录
LM3886TF/NOPB数据手册
Page:
of 24 Go
若手册格式错乱，请下载阅览PDF原文件
Electrical Characteristics (Notes 5, 6) (Continued)
The following specifications apply for V
+
= +28V, V
−
= −28V, I
MUTE
= −0.5 mA with R
L
=4Ω unless otherwise specified. Limits
apply for T
A
= 25˚C.
Symbol Parameter Conditions
LM3886
Units
(Limits)
Typical
(Note 10)
Limit
(Note 11)
CMRR
(Note 3)
Common Mode Rejection Ratio V
+
= 60V to 20V, V
−
= −20V to −60V,
V
CM
= 20V to −20V, I
o
=0mA
110 85 dB (min)
A
VOL
(Note 3)
Open Loop Voltage Gain |V
+
|=|V
−
| = 28V, R
L
=2kΩ, ∆V
O
= 40V
115 90 dB (min)
GBWP Gain-Bandwidth Product |V
+
|=|V
−
| = 30V
f
O
= 100 kHz, V
IN
= 50 mVrms
8 2 MHz (min)
e
IN
(Note 4) Input Noise IHF — A Weighting Filter
R
IN
= 600Ω (Input Referred)
2.0 10 µV (max)
SNR Signal-to-Noise Ratio P
O
= 1W, A-Weighted,
Measured at 1 kHz, R
S
=25Ω
92.5 dB
P
O
= 60W, A-Weighted,
Measured at 1 kHz, R
S
=25Ω
110 dB
IMD Intermodulation Distortion Test 60 Hz, 7 kHz, 4:1 (SMPTE)
60 Hz, 7 kHz, 1:1 (SMPTE)
0.004
0.009
%
Note 2: Operation is guaranteed up to 84V, however, distortion may be introduced from SPIKe Protection Circuitry if proper thermal considerations are not taken
into account. Refer to the Thermal Considerations section for more information. (See SPIKe Protection Response)
Note 3: DC Electrical Test; refer to Test Circuit #1.
Note 4: AC Electrical Test; refer to Test Circuit #2.
Note 5: All voltages are measured with respect to the GND pin (pin 7), unless otherwise specified.
Note 6: Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. Operating Ratings indicate conditions for which the device is
functional, but do not guarantee specific performance limits. Electrical Characteristics state DC and AC electrical specifications under particular test conditions which
guarantee specific performance limits. This assumes that the device is within the Operating Ratings. Specifications are not guaranteed for parameters where no limit
is given, however, the typical value is a good indication of device performance.
Note 7: For operating at case temperatures above 25˚C, the device must be derated based on a 150˚C maximum junction temperature and a thermal resistance
of θ
JC
= 1.0 ˚C/W (junction to case). Refer to the Thermal Resistance figure in the Application Information section under Thermal Considerations.
Note 8: Human body model, 100 pF discharged through a 1.5 kΩ resistor.
Note 9: The operating junction temperature maximum is 150˚C, however, the instantaneous Safe Operating Area temperature is 250˚C.
Note 10: Typicals are measured at 25˚C and represent the parametric norm.
Note 11: Limits are guaranteed to National’s AOQL (Average Outgoing Quality Level).
Note 12: The LM3886T package TA11B is a non-isolated package, setting the tab of the device and the heat sink at V
−
potential when the LM3886 is directly
mounted to the heat sink using only thermal compound. If a mica washer is used in addition to thermal compound, θ
CS
(case to sink) is increased, but the heat sink
will be isolated from V
−
.
Note 13: The feedback compensation network limits the bandwidth of the closed-loop response and so the slew rate will be reduced due to the high frequency
roll-off. Without feedback compensation, the slew rate is typically larger.
Note 14: V
−
must have at least −9V at its pin with reference to ground in order for the under-voltage protection circuitry to be disabled.
Note 15: The output dropout voltage is the supply voltage minus the clipping voltage. Refer to the Clipping Voltage vs Supply Voltage graph in the Typical
Performance Characteristics section.
Note 16: The Differential Input Voltage Absolute Maximum Rating is based on supply voltages of V
+
= +40V and V
−
= −40V.
LM3886
www.national.com 4
Downloaded from Elcodis.com electronic components distributor
器件 Datasheet 文档搜索
AiEMA 数据库涵盖高达 72,405,303 个元件的数据手册，每天更新 5,000 多个 PDF 文件
