Datasheet 搜索 > 电机驱动器 > TI（德州仪器） > DRV8302DCA 数据手册 > DRV8302DCA 产品设计参考手册 5/11 页
器件3D模型￥ 14.599
DRV8302DCA 产品设计参考手册 - TI（德州仪器）
制造商:
TI（德州仪器）
分类:
电机驱动器
封装:
HTSSOP-56
描述:
TEXAS INSTRUMENTS DRV8302DCA 芯片, 电机预驱动器, 三相, 56HTSSOP
Pictures:
3D模型
符号图
焊盘图
引脚图
产品图
页面导航:
应用领域在P1P2P3P4P5P6P7P8P9P10P11
导航目录
DRV8302DCA数据手册
Page:
of 11 Go
若手册格式错乱，请下载阅览PDF原文件
C2000™ Systems Applications Collateral
v1.0
5
Software Setup
The QSG GUI (InstaSPIN-BLDC_GUI_DRV83xx_v100.exe) can be located on the drive that is shipped with the
kit or once controlSUITE is installed at the following location:
controlSUITE\development_kits\DRV8312-C2-KIT_vXXX\~GUI\
The GUI requires Microsoft .NET framework 3.5 SP1 or higher to run. Please ensure that this software is
installed prior to running this program.
The kit ships with a F28035 controlCARD which is pre-flashed with the code that enables interface to this GUI.
The flash image can be re-flashed using CCS if needed.
Running the GUI
1) Make sure all the jumper and connector settings are as described in the Hardware setup section.
2) Browse to and double click on BLDC_Int_GUI_DRV83xxv*.*.exe The GUI window should pop up (Fig
3).
3) The GUI should auto-detect and connect to your DRV830x-HC-EVM. If auto-connect fails you will need
to set up the connection manually. The Connection Wizard is accessed through the Connection menu.
Click on “Connect to engine” to view a list of available targets. Now setup the Connection Wizard Dialog
to match Fig 4. Select Piccolo 28035 from the Target list and Serial for connection method. You will
need to determine the correct COM port number for your system. This can be found by going to Control
Panel->System->Hardware tab->Device Manager->Ports(COM & LPT). And look for the one which is
described as USB Serial Port or similar. Hit Connect once done.
Fig3: GUI Startup
器件 Datasheet 文档搜索
AiEMA 数据库涵盖高达 72,405,303 个元件的数据手册，每天更新 5,000 多个 PDF 文件
