Datasheet 搜索 > ON Semiconductor（安森美） > NCP1034 数据手册 > NCP1034 产品设计参考手册 1/16 页
￥ 0
NCP1034 产品设计参考手册 - ON Semiconductor（安森美）
制造商:
ON Semiconductor（安森美）
描述:
100V同步PWM降压控制器 100V Synchronous PWM Buck Controller
Pictures:
3D模型
符号图
焊盘图
引脚图
产品图
页面导航:
原理图在P2
型号编码规则在P16
标记信息在P16
功能描述在P1
导航目录
NCP1034数据手册
Page:
of 16 Go
若手册格式错乱，请下载阅览PDF原文件
© Semiconductor Components Industries, LLC, 2016
January, 2016 − Rev. 2
1 Publication Order Number:
EVBUM2356/D
EVBUM2356/D
NCP1034 Buck Converter
Evaluation Board User's
Manual
Table 1. GENERAL PARAMETERS
Device Input Voltage Output Voltage Output Current Voltage Ripple Topology I/O Isolation
NCP1034 48 V ±20% 5V 5A < 30 mV Buck
None
Description
This evaluation board user’s manual describes high voltage, high
power and high efficiency DC/DC buck converter featuring the
NCP1034.
The NCP1034 is voltage mode PWM controller for a high voltage
synchronous buck. The controller drives two external N-MOSFETs
with programmable frequency up to 500 kHz for wide applications
range. The IC is able to be synchronized by external signal or is able to
synchronize other ICs that simplify design of system level filter.
The output voltage can be set as low as 1.25 V. Besides system and
drivers UVLO there is an external UVLO that can be set to user value.
Over current protection uses low side MOSFET R
DSON
as sensing
resistor, which has no impact on efficiency. Current limit protection
uses a hiccup mode. These protections provide application additional
security level.
Connection Diagram
Figure 1. Connection Diagram
Power
Supply: 48 V
±20%
Load: 5 V
< 5 A
Shut
Down
Ext.
Sync
Signal
+
−
+
−
+
−
+−
www.onsemi.com
EVAL BOARD USER’S MANUAL
K
ey Features
• High Input Voltage
• High Operation Frequency
• High Efficiency
• Low Output Voltage Ripple
• Ceramic Capacitors Only
• Over-current Protection
• Under-voltage Protection
• Start to Pre-biased Output
• Small Size
器件 Datasheet 文档搜索
AiEMA 数据库涵盖高达 72,405,303 个元件的数据手册，每天更新 5,000 多个 PDF 文件
