Datasheet 搜索 > NXP（恩智浦） > P89LPC932FDH 数据手册 > P89LPC932FDH 数据手册 2/60 页
器件3D模型￥ 1.902
P89LPC932FDH 数据手册 - NXP（恩智浦）
制造商:
NXP（恩智浦）
封装:
TSSOP
描述:
8位微控制器，带有加速双时钟80C51核心8 kB的闪存，512字节数据EEPROM和768字节的RAM 8-bit microcontroller with accelerated two-clock 80C51 core 8 kB Flash with 512-byte data EEPROM and 768-byte RAM
Pictures:
3D模型
符号图
焊盘图
引脚图
产品图
P89LPC932FDH数据手册
Page:
of 60 Go
若手册格式错乱，请下载阅览PDF原文件
Philips Semiconductors
P89LPC932
8-bit microcontroller with accelerated two-clock 80C51 core
Product data Rev. 04 — 06 January 2004 2 of 60
9397 750 12379
© Koninklijke Philips Electronics N.V. 2004. All rights reserved.
■ Oscillator Fail Detect. The Watchdog timer has a separate fully on-chip oscillator
allowing it to perform an oscillator fail detect function.
■ Configurable on-chip oscillator with frequency range and RC oscillator options
(selected by user programmed Flash configuration bits). The RC oscillator option
allows operation without external oscillator components. Oscillator options
support frequencies from 20 kHz to the maximum operating frequency of 12 MHz.
The RC oscillator option is selectable and fine tunable.
■ Programmable port output configuration options:
◆ quasi-bidirectional,
◆ open drain,
◆ push-pull,
◆ input-only.
■ Port ‘input pattern match’ detect. Port 0 may generate an interrupt when the value
of the pins match or do not match a programmable pattern.
■ Second data pointer.
■ Schmitt trigger port inputs.
■ LED drive capability (20 mA) on all port pins. A maximum limit is specified for the
entire chip.
■ Controlled slew rate port outputs to reduce EMI. Outputs have approximately
10 ns minimum ramp times.
■ 23 I/O pins minimum (28-pin package). Up to 26 I/O pins while using on-chip
oscillator and reset options.
■ Only power and ground connections are required to operate the P89LPC932
when on-chip oscillator and reset options are selected.
■ Serial Flash programming allows simple in-circuit production coding. Flash
security bits prevent reading of sensitive application programs.
■ In-Application Programming of the Flash code memory. This allows changing the
code in a running application.
■ Idle and two different Power-down reduced power modes. Improved wake-up from
Power-down mode (a low interrupt input starts execution). Typical Power-down
current is 1 µA (total Power-down with voltage comparators disabled).
■ 28-pin PLCC, TSSOP, and HVQFN packages.
■ Emulation support.
Downloaded from Elcodis.com electronic components distributor
器件 Datasheet 文档搜索
AiEMA 数据库涵盖高达 72,405,303 个元件的数据手册，每天更新 5,000 多个 PDF 文件
